It is possible to clone an entire hard drive or specific partitions on a hard drive. This is useful if you are upgrading to a larger hard drive. With Macrium Reflect you can boot the target disk on the same system after cloning. Cloning your hard drive creates a bootable new hard drive with the state of your computer at the time you undertook the clone.You can clone to a hard drive installed in your computer or to a hard drive installed in a USB hard-drive Caddy.
Important
Deleting and re-configuring existing partitions or configuring new partitions is possible with Macrium Reflect, so you don't need to do this prior to cloning.
Select the disk you wish to clone in the main application window and Click 'Clone this disk'..
In this case MBR Disk 1[0F0452A1].- In the wizard that opens Click Select a disk to clone to...
- Select the hard disk you wish to clone to. In this case, there is only one disk available.
If you do not want to modify the order or size of partitions of the clone, click Next. This is the default behavior.
Alternatively, drag the partitions you want to clone, the red arrow below shows this.Becomes
In this example, there is 400MB of free space after the copied partition. You can modify the size of each partition to fit the new disk if required.
You can delete partitions on the target disk by selecting and clicking 'Delete existing partitions'..To modify the partition sizes, click Cloned Partition Properties and adjust the size of the partition by:
- Setting the partition size precisely using the Partition Size entry box.
- Resize the partition automatically by clicking Maximum size, Minimum size or Original size.
- Click OK.
- If required, click Advanced Options to:
- Perform an intelligent sector copy, that only copies sectors in use on the source file system. Select to:
- Verify File System, prior to cloning.
- Rapid delta clone, to only copy the differences between the source and the target.
- Enable SSD TRIM, to increase the lifetime performance of the device by flagging unused blocks.
- Perform a forensic sector copy, that copies all sectors from the source disk whether they are in use or not.
- Click Next.
The options to Add Schedule, Edit Schedule or Delete Schedule is displayed.
Click 'Add Schedule' to optionally schedule your clone
Make any required changes and click Next.
For more information see Scheduling backups. - Review the settings and click Finish.
Verify the settings in Backup Save Options and if appropriate, click OK.
Note: Saving a backup definition enables you to run your Clone at any time with a single clickNote: You must save your backup definition if you have created Clone schedules. Your schedules cannot run if this step is missed.If you want to run the Clone at this point, select 'Run this backup now' and click OK.
A Warning box appears, if appropriate click Continue.
Important
The target disk for the clone operation will be overwritten. This is unrecoverable, so please ensure that the target disk contains no valid data.
The clone operation now starts.
Incompatible Disk Selected
If you receive the error message 'Incompatible Disk Selected' when cloning then please see this article for more information: Incompatible Disk Selected